Stainless Steel Flocking Seive
F.A.Q. - How do I use Flocking Powder
Firstly : Do not breath in the dust.
Apply some glue to the area to be covered with a brush
Work over a large piece of paper (so you can put the unused material (spills) back for next time
Use a food strainer to sieve the flocking over the desired area. Using a large brush and your finger, work the flocking down onto the glued area.
Leave it about 5 minutes till the glue has dried. A hair drier will help speed up the process and also help remove the extra material.
Tap the part over your paper to remove any loose material.
Many different coloured Flocking Powders and Coloured Glues are available
Product ID: 5848
People who bought this, also purchased these:
1:20 - 1:24 Weld Lines
1:12 Honda RS250RW Exhaust Pipe (Hasegawa)
Professional (Stainless Steel) Scalpel Knife Handle 0933
Professional Scalpel Blades No.10 - 5 Pack
Professional Scalpel Blades No.10a - 5 Pack
Professional Scalpel Blades No.15T - 5 Pack
Fine Drill Pin Vice (0.1-1.0mm) - 74051
40mm Masking Tape - 87063
Grey Model Filler / Putty (Fine) 180g
Polishing StiX (Micromesh) #1107
Pink Paint 30ml - Similar to Tamiya X17
Ducati 916 Senna Display Base for Model Kits 300x160mm
1:20 Matra MS80 verB Full detail Multi-Media Model Kit
1:12 Honda RC213V Test 2014/2015 (M. Marquez / C. Stoner) Resin and Decals
1:12 Ducati 916 Senna 95 '/ 97' / 98 'Transkit (Resin, Photoetch and Decals)
1:24 Toyota Celsior Auto Couture 21 Kaiami Model Kit
1:24 Lamborghini Countach 5000 Quattrovalvole Special Model Kit
1:24 Lamborghini Countach 5000 Quattrovalvole Model Kit
1:24 Fast and Furious '69 Chevy Camaro Yenko Model Kit
Z-Poxy (15 Minute Clear Epoxy Glue) 120ml (4oz) PT-35